Your automatic sliding gate opener will be connected directly to its control box. Company Introduction. Olide autodoor. Automatic sliding doors residential sliding door openers Magnetic drive sliding door opener Automatic swing doors Automatic window opener sliding gate opener Swing gate opener Automatic sunshade motor Automatic hospital doors Automatic folding door system Roller Shutter Automatic Barrier Gate Automatic revolving door Access Control System.
You are here: Home. Be the first to comment! Read times. Send an inquiry. Contact us Skype: chinentech Whatsapp: 86 E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it. Information How to order Brochure Download. Payment Method. Powered By T3 Framework. The motor needs a suitable concrete pad to be installed on that is level.
If the motor is to be powered by V mains you will need an electrician to take care of this. The motor can be hardwired where the power cable is feed through the pad the motor is fitted to or a Power Point can be fitted next to the motor. If using Low voltage or solar power a low voltage cable can be feed through the motor pad and to a transformer or solar panel. There is no such thing as one motor for all gates, different motors are suitable for different applications.
Place a length of rack on the output gear of the motor against the back face of the gate to check that it lines up with the output gear correctly. Open and close the gate to see that this is consistent for the whole length of the gate. The bottom rail must be straight otherwise the spacing between it and the motor may very too much and the rack not contact the output gear in places, which could stop the gate working.
The rack must fit on the bottom rail of the gate for the entire open and close movement. If it comes off the bottom then the motor will need to be packed up, if it comes off the top then the gate wheels may need to be packed to lift the gate higher or other means for fitting the rack may need to be implemented.
The motor pad may also be lowered if necessary. Most sliding gate motors have a base plate that either bolts to the pad and then the motor bolts to the base plate, although some motors bolt directly to the pad. Some Italian motors have bolt pins that are too be concreted into the pad, which isn't all that practical although these can be replaced with normal bolts. A couple of lengths of suitably sized box section aluminium or galvanised steel can be used to pack the motor up.
These would ideally have holes drilled into them so they can be dyna bolted to the concrete pad or metal screwed to a metal pad then the motor screwed to the box sections where ever it can be. It's important the the motor is fixed near the edges so it is firm and doesn't move at all when the gate is moving. To fit the rack start with the gate nearly closed and place the first length of rack on the motors output gear aligned with the mark made previously on the gate.
Using an electric drill attach the rack using tek screws in the centre of the slots in the mounting lugs. When fitting the second length of rack make sure the that it is firmly clipped together so the tooth spacing is consistent at the join, other wise the gate may jump when the joint goes over the output gear.
Once all the lengths of rack are fitted cut the last one to length if necessary using an angle grinder with a steel cutting blade because the rack has a steel rod in the middle. Do not connect any photocells, digital keypads, intercoms etc Power up the motor then set the remote controls. Then set the open and close limits for the gate. There are different methods for determining where the fully open or closed position of a sliding gate is.
0コメント